Recent content by bloodlord77

Greetings all. Just wanted to share the new addition to my M&P family. It's a 2.0 Compact 4" with the new trigger and optics ready slide. I picked up a Holosun SCS MP2 that mounts directly to the slide instead of having to use a plate. This my first venture with optics on a handgun. It presents...

After a short honeymoon period with my 4.6" model flawlessly cycling 40 S&W level range ammo, I started trying out the Underwood 200 gr. Hard cast ammo. I was having consistent failures to feed on the 3rd or 2nd from the last round in the magazine. I bought the M&P 10MM for a woods gun, not for...

I wonder what the likelihood of the adhesive holding on that front polymer strap wearing out, and it starting to peel off.

Unconfirmed by me but, I'm sure the Apex kit for the .45 2.0 would work just fine. You could contact them and ask. Not a fan of the new flat faced trigger?

The rear pin on my 2.0 compact 3.6" shifts a little bit back and forth,but never protrudes from the frame. I've noticed this during live fire only. But I also have ran 500 round sessions through it, and it never moved outside of the frame either way. So, I'm confident it will get me through any...

The 2.0 models have metal mag releases. The 1.0 models have plastic releases with a metal tab that catches the magazine. The plastic one will probably work fine in your 2.0 I have a 1.0 357 Sig fullsize. I've never had an issue with the plastic mag release.

Why not just use a 17 round magazine and the provided mag adapter? Then you have a 3.6" slide on a fullsize frame essentially.

That makes perfect sense. I was thinking of looking at the 507. Any idea what the difference between the C and K are?

So I did a quick check. The 10mm complete slide went on the .45 frame and functioned normally. The .45 complete slide would not go on the 10mm frame. If trying to use the 10mm barrel and rsa in the .45 slide, you can see the amount of slop and gap in the pics. Looks like you'll just have to...

Hmm. I have both the .45 and 10mm 4.6" I'll try a slide swap and see what happens.

The M&P sights are on the short side of "optic height sights". Not nearly as tall as my XDM 10 OSP suppressor sights. My poi at 15 -20 yards was pretty much combat hold with the M&P.

After reading through issues people have been experiencing with the M&P 10mm, I figured I'd share my positive experience with my sample size of one. Today I went and picked up my new 4.6" model from my FFL. Brought it home, disassembled, cleaned, and lubed it up, and headed out back with a grab...

I use a Tulster Profile iwb holster. Fits the 2.0 Compact 3.6" and the 2.0 Subcompact.

Good luck with your endeavor. I would be afraid to put anything inside my pistol that with heat could possibly dislodge and induce malfunctions. Unless it was an experimental fun gun. Then, no harm no foul.

Here are the specs. Can't wait!!!! This is the full-size model with optic cut.