Recent content by fred5876r

I put a Dawson FO rear sight on my M&P22 for the reasons stated. However, to get it to shoot to point of aim, I had to use a HiViz front sight (the Dawson was too tall).

When my Clark Custom barrel was new, my 41 would often not extract an unfired round. I sent the gun and barrel to Clark and according to their Invoice they "tuned" the extractor and polished the chamber. When I got it back, I could tell no difference - same problem. I let a local gunsmith...

If you don't mind, where did you find a 986 in stock?

Here is mine with a DeltaPoint on an Allchin mount. Great package for steel.

41 is SPF. Thanks. I offer for sale a beautiful Model 41 in about like new condition. The only noticeable flaws are some small scratches on the left side of the slide (above the slide hold-open lever), and a small chip out of the bottom of the right side grip, as shown in the photos. Round...

I am definitely interested. I have two C.O.R.E. pistols - I have a Trijicon RMR on a full-size, but my 5" I plan to leave with (Dawson) iron sights, for a ESP gun.

WTS: Allchin C-More Mounts for S&W Model 41 The Allchin mounts are SPF.

I offer 3 Weaver style scope mounts for S&W revolvers by Weigand Combat - one black and two silver. They are in excellent used condition with mounting screws. $15 each shipped.

I put the Dawson FO sights on my M&P22 (front and rear - I think the factory rear sight is horrible), and I found that it shot low, even with the .160 front. I replaced the Dawson front with a HiViz FO front (#MP2012, designed to be used with factory adjustable rear sight), which is just a...

I bought a IWB holster here: In The Waistband Holster by The Well Armed Woman I am very pleased with it. Extremely slim and lightweight, and it fits my gun perfectly - not too loose, not too tight. This model and color are in stock for immediate shipping (otherwise I would have got a plain...

CCI Standard Velocity works perfectly in mine. So long as it cycles properly, I think logic suggests that it will be easier on the gun over time than high velocity rounds.

Apex sear and USB, TruGlow TFO sights, Talon grip, Pearce extensions. All highly recommended.

I bought two Pearce extensions for my Shield's two 7 rounders, and they are great - perfect fit, just the right size, and look great. However, when I figured out they work every bit as well on the 8 round mag, I realized I should have ordered 3. The 8 round mag with extension is perhaps not so...

I have Talon rubberized on four M&Ps and I think they are fabulous.

I center the red FO of the front sight on the target (i.e. where I want the bullet to strike) and then line all 3 FO up. If I was holding at 6 o'clock even the .160 front would be too tall! I found my Dawsons to be as loose in the slots as the factory sights. Easily slid in place by hand with...