Recent content by Golfbuddy45

Withdrawn.

I love wood and have bought several wood grips for my S&W's in the past. Doing some cleaning up in the house so offering these grips at a nice deal for both of us!! These nice N-Frame Wood Grips I think are made of Goncalvo Alves. I bought these many years ago and do not remember exactly what...

Jim Dubell was the owner of Delta Gunshop and Clearwater Reboring. He did great work and did a complete rework of one of my Marlin 1894SS .44Magnum Lever Rifles to a one of a kind Marlin 1894SS .45 Long Colt with SAAMI SPEC 1:16 Twist Rate. All Marlin .45LC rifles were made with a 1:38 Twist...

S&W says the 686 is a K Frame while the 629-6 Classic is a N Frame yet the frames look identical to me and while the grip on the 686 is a K grip and the 629 has an "N" grip they seem to be interchangeable except for the tabs that stick up at the top of the grips..... 686- K Frame 629-6...

Both of my S&W are N frames.. I will probably sell the grips later in the S&W ads here once I am sure what they are for. I am quite happy with the grips on my two S&W's as you can see below :):D 686 Custom .357Mag on top. I have since removed the scope and base and shooting it straight...

Sorry - I have a 629 .44Mag and a 686 Custom in .357.. not 626.. Thanks, GB

A friend gave me these beautiful grips and I can not identify what they go to. They do not fit my N Frame 626 or 629. He thought they were for an old S&W .22 cal revolver. Any help identifying would be greatly appreciated....

After much finagling I was finally able to get the cylinder open and the problem was the Knurled Ejector Pusher Rod was loose. I was able to tighten it and it works perfectly now. It was very useful to know about the LEFT HAND THREAD too... Thanks.

Since I have not seen the inside yet please explain - I assume the EJECTOR ROD is attached to the THUMB PAD you push toward the cylinder that presses in the locking pin in the cylinder - - correct?

The push lever does not appear to be pressing far enough to release the cylinder to load/unload. Where can I find a good schematic of a 629-3 and Parts List? Is there a trick to releasing the cylinder when the button is not working? GB45

I'LL TAKE IT - on the #5 629-8. GB45 PM SENT

I'll Take It I will take the S&W 29-3 for $835 shipped. PM sent.. GB45

Thanks for this info on that book - will check it out..... GB45

By the way is SCSW a person or a resource?? Thanks to whichever - - GB45

Thanks so much for the fast response. That's why this is such a great forum..... GB45