Recent content by Kudumaned

  1. K

    cancer

    sorry for your loss. God Bless
  2. K

    6906/ double stack grip size comparison

    My experience has been different between the two. I have a M&P9C with the medium backstrap that fits and shoots great. I also have a 4013TSW with factory and hogue grip. With the factory grip it feels ok but still too big and with the Hogue significantly too big. I believe the 6906 and 4013TSW...
  3. K

    4013 TSW Tactical Clarity

    MSF1xxx here, front strapping-no rail. Didn't know what MSF stood for kinda cool!
  4. K

    Safety vs No Safety

    I carry M&P9C with manual safety on in iwb holster. I carry 4013TSW with hammer decocked safety on. I figure theres more of a chance of an accidental discharge with safety off than i need to use the gun for self defense. If i have to be fastdraw, safety off ready to go and accurate i'm probably...
  5. K

    Shorty Forty mags

    Nice pistol, good for you. I like tt gunleather and rgrizzle for leather holsters the best. Both make holsters for the shorty 40. Enjoy!
  6. K

    3914 Slide release problem?

    Hmmm, is the sideplate the part that the pin at the rear of the slide release goes up against?
  7. K

    3914 Slide release problem?

    Sure does, must be ok.
  8. K

    Hogue grip parts 3914 question

    Thanks! that would be great presspics. PM sent.
  9. K

    3914 Slide release problem?

    The slide release on my 3914 is at a little slant and the pin that comes out the end barely touches the part behind it. My 4013TSW slide release is more horizontal and the pin hits more in the middle of the part behind it. Haven't had any issues with the 3914 but could this be a problem in the...
  10. K

    Hogue grip parts 3914 question

    I have the wood grip panels for 3914 from Hogue. I do not have the blocks and screws to install them. Are the blocks and screws for the Hogue rubber grips the same as for the wood grips? If so i may order the rubber grips to try both the rubber and the wood grips. Please advise. Thanks
  11. K

    Compact 3rd generation pistols

    Greg, was the gun 2 tone to begin with? Looks great
  12. K

    Tell me about your 4013TSW

    I've had mine for 3 months, put about 500 flawless rounds through it. Fun to shoot, 0 problems.
  13. K

    New guy

    Welcome, i can only offer my recent experiences. I bought the M&P 9C, like the gun but have had a few issues with it. I've had 2 or 3 failures to lock back (within first few times at range), magazine has recently started coming out when shooting (didnt until after about 750 rounds) a few times...
  14. K

    Holster for 3953 same as 3914?

    Hi Presco, no thumb break, i'm looking at cover up or cover up plus. I'm curious why it would matter though?
Back
Top