Recent content by mcslim

I believe that the standard M-460/500v rubber grips (Hogue) cover the front and back straps. Fills a large hand well and is excellent on shock absorbsion for any caliber. They fit any K/L/N/G-frame, round butt only. SKU#294670000 in Black (or survival Orange) for $37. Slim

I have several sets of N-frame Pachmayr grips and some have a special screw that has a thined waist in the middle section to barely clear the mainspring. I lost one once and tried to use a standard full diameter gripscrew from a K-frame and it interfered. Also make sure that some "gunsmith"...

There is no cover finish on the polished aluminum models. I have modified this finish on several adaptors. Everything from sand blast (Very rough/stippled) through glass beads, walnut shells, to baking soda (Very Light matte: matches the 300 series silver scandium/aluminum guns well). For the...

It will not cover up the lock hole, neither will the C&S latch.

I first bought the SDM F/O sight from Midway (@$28) and it was OK, but later changed to the patridge style with gold bead (@$50). Not really any better but it now matches exactly my 627PC and SSR. No trouble CCH drawing with the square front sight edge. The rear adjustable sight is slightly more...

What does it take to be a real "Mountain Gun"? I have aquired a clean and tight Nickle M25-5 in .45lc with 4inch barrel and half lug. #N8425XX 95% Full TT/TH/TS/RR/WO/SB Ribbed: barrel top, F&R sights, F&R gripstraps Does it have to be engraved on the barrel or is it just a general...

Are you reffering to the replacement fixed rear combat sight used on some NiteGuard models? It is made by Cylinder&Slide. I have used them on several guns. They come with white dots or plain black. They are available from Midway and others for $90-120. M. C. Slim.

My M325 NG (.45acp/230gr) shot 5" low @7yds too with the sight pattern I use. I made a spacer from an old adjustable S&W sight base that I put under the C&S fixed combat sight w/ longer screws. Was about 1/8th inch thick. It brought POI/POA up to 1" high now. Later, I might trim it another .025"...

Just recieved my December 18 order of 5 adaptors after an advertised 8 week wait. This is the second order that I have made since they restarted shipping and I am quite satisfied with service and quality. Each of my orders were followed with a confirmation phone call and then immediate shipping...

I don't think the C&S sight will work. I have two and they only fit K,L and N-frames. The J-frame adjustable sight is just a little smaler and has a tinier screw and threads. I wish it would work, or there was another reasonable alternative, as I also have a 60-15 that I would like to convert to...