Recent content by ohbejuan

Anyone shot 308 subsonic out of your M&P 10? If so, what brands? Any info on cycling and accuracy would be appreciated.

Mine's done! Just took it to the range today :D Everything ran perfect except CCI Quiet

I have a sparrow on the way, according to cmichael they are still visible!

Anyone installed Tall Sights on their M&P 22 or M&P 22 Compact? Trying to make both suppressor ready and find some sights that would be visible over the can

Has pin, not from PSA. Never would've known it existed until seeing this! S&W Should treat you right, they've always done well for me

Just from looking at the pictures, it looks like the DP Pro has a god-awful tint (just like the RMR does) in the name of "coating"...I liked the DP originally because of the clear (seemingly tint-less) glass, not really wanting to look through a yellow or blue filter...

Thanks! Great info!

Did CCI Quiet cycle reliably without holding it closed?

I'm sure this has been discussed a long time ago, but is there a "best" or favorite type of threaded barrel adapter for the M&P 22 (NOT Compact)? I'm specifically looking for one that would support the SilencerCo O-Ring engagement From what I understand they do not use the same adapters at the...

Has anyone tried the TROS adapter? Any opinions?

Thanks for the info! How did you guys go about measuring your overall (estimated) length? I get it measuring from the back of the stock extended, but what's the best way to gauge how far the 4.5" barrel will extend out? Or did you do something like subtract 11.5" from the factory 16" length to...

That guide doesn't look that bad actually. Thanks Since I was considering a 4.5" barrel, I'm assuming that's what goes in the barrel length field? (Note, I saw where one guy said his bolt sometimes fails to lock back on an empty mag with a 4.5, anyone had this problem?) I also read where the...

Any chance someone would be willing to share some info on exactly how they filled out the form 1 on the e-file site? I've seen a couple of help guides, but it still seems somewhat complex. I already have a trust setup though. I'm thinking the 4.5" ADCO cutdown with the SilencerCo threads would...

Dullh, that was pretty much exactly what I was looking for, thanks! The only question I have on that is, do you send your entire upper to ADCO or just the barrel? I don't really have a good vice and haven't installed a barrel/gas block myself. The same with the OP's rail that had been cut down...

I'm not entirely clear on the SBR/cut down process, can you elaborate a bit? Submit form 1 with specified length +200, form gets returned. Then you send your existing barrel out to ADCO and have them cut and send back? Did you use a trust, can they send directly back to a trust F1 out of...