Recent content by old and infirm

  1. O

    Nickle 19

    700.00 plus tax . Has Harret grips , the extractor rod slipped in the vise but locks up tight and the nickle finish is good . I know you guys want photos posted but not as bad as I want too . New internet line today with upgraded service , new computer tomorrow . Then I will Be " posten " . What...
  2. O

    Nickle 19

    Saw a nickle model 19 today in a pawn shop , it had a 6 inch barrel pinned , recessed cylinder and a target style front sight with a red insert . The serial Number started with 38 K . Never saw a serial number start that way is that unusual ?
  3. O

    HD Pump Shotgun always loaded

    I have seen two 870's made in the last five or so years require spring replacement . Both weapons failed to present the last couple of rounds from the magazine . You could feel no resistance when you attempted to depress the magazine spring . Both were high capacity tactical weapons one with a...
  4. O

    pin keeps coming out after firing

    Does your weapon have a higher round count , if so replace the recoil spring , see if that cures the problem .
  5. O

    If I were made a deputy in 1930.....***UPDATED see post #50

    Even I'm not old enough to have been a deputy in 1930
  6. O

    model confusion

    While going through" Pictures and Albums " on this forum I found a picture of a second model opened with the bolt lock visible . What I have is a second model frame with a third model upper and cylinder . It times locks up and , although not checked with range rods , appears to line up cylinder...
  7. O

    What's in your .380?

    I personally shot a Gold Dot from a LCP into ballistic gelatin through a quilted coat and T shirt , F. B. I. protocol , and got a four and half inch wound channel five and half long with ten and a half inches penetration . The round expanded about 6o% with 100% weight retention .
  8. O

    gun trading private sales

    Local police will run a NCIC check to determine if its stolen
  9. O

    model confusion

    The number on the top latch matches the number on the cylinder, which only has a single row of notches like a modern Smith . The info from this site is invaluable and I know how much it would help if I could post photos. I thank you guys
  10. O

    model confusion

    I have to agree I don't think you could put a third model cylinder on a second model frame as the bolt lock or cylinder lock would seem to be different between the two models . But as I look at the weapon the cylinder has the appearance of a modern Smith . The trigger has cut out on the rear the...
  11. O

    model confusion

    Well got my 38 S & W double action with hammer second model kind of . The serial number 92XXX comes back to a second model but there is a number on the cylinder 163XXX . The cylinder appears to be a third model and the trigger appears like a second model . The grips are S&W in black and red ...
  12. O

    Age info on a 38 double action top break

    I will again attempt to add photos as I now have them on my desk top and in photo bucket . My original posts were in an attempt to learn a little for a trade on this revolver , and I now have my hands on it . It has red and black plastic grips although one has a piece missing . My biggest...
  13. O

    Age info on a 38 double action top break

    Yes you are correct in your description , thanks for the info , pictures to follow I hope
  14. O

    Age info on a 38 double action top break

    Any help dating a 38 double action top break serial 92XXX . Thanks , pictures to follow , big talk for a techno illiterate .
  15. O

    32 S&W 38 S&W

    In the same , as much as possible , top break which is worth more 32 or 38 S&W
See more
Back
Top