Jdavis
Member
Are side plates fitted to each revolver or are they interchangeable
with any gun of the same frame size.
with any gun of the same frame size.
Side Plates
- Thread starter Jdavis
- Start date
Register to hide this ad
Factory fitted but used ones can sometimes be easily fitted to another gun.
- Joined
- Aug 21, 2005
- Messages
- 8,018
- Reaction score
- 7,100
This is not a job for an amateur as side plate fit is a really close, precise fit such that, if done correctly, the seam is really hard to see.
DWalt
Member
Restricting comments to S&W sideplates, there are some who can fit them correctly, but without a lot of experience, most people won't be able to do a respectable job. Or you could get lucky.
It is possible, but unlikely, that another side plate will fit perfectly in a pre-1980 revolver. Newer models are more likely to be interchangeable. The primary issue will be the mismatch in the finish.
Plus you have the 4 screw side plates and the 3 screw side plates. What frame are you looking to replace the side plate on and why. I have an N frame side plate laying in my parts pile.
OP
Jdavis
Member
This is as I suspected. I have a model 10-6 that has some pitting and considered replacing it. I found a side plate available on "the- bay" for a K-frame. When inquiring about the plate, he informed me of his qualifications as an armorer and gunsmith and assured me that he had never seen one that wouldn't interchange. I was doubtful, but made the purchase and of course the side plate would not fit. The seller agreed to accept the return but implied that I must not know what I am doing.
Last edited:
TenTea
Member
I recently bought one *on spec* for a Victory model because it was in excellent condition and inexpensive.
If it doesn't fit my project gun properly, I will use it as a *sideplate & frame screw holder* on my bench for when any Smith's get disassembled.
I may mount it on an oak board or some such.
If it doesn't fit my project gun properly, I will use it as a *sideplate & frame screw holder* on my bench for when any Smith's get disassembled.
I may mount it on an oak board or some such.
