Search results

I have a few Model 19 and the oldest is a 19-2. They are all 2,5” barrel. I have a 19-6 that the hammer has been bobbed, has had an amazing trigger job done to it and I want to know who is the best to send it to for magna ports? TIA

I will ask them when they respond to my email. It being a holiday they may have shut down for the three day weekend. Thank you.

Yes they are the stock grips. The grips are made by Ahrends Grips. I do believe it is contoured to the grips. Your ideal about the grips may be the very answer. I would think if it was liquid I would have found some rust, but I didn’t. Both of your ideals beat all I have heard so far. I have...

Can anyone explain why my 325PD is unfinished under the grip? I bought it used and was just curious. I own other PD revolvers and they do not look like this. Photo was taking in the middle of taking off side plate. So I know the screws are missing.

I bought me a S&W 9mm EZ PC with the thumb safety because I normally carry a 1911 and wanted to keep the same platform. The issue and I guess it isn’t a huge issue is the grip safety is sharp at the top and cuts the web of my hand. If I polished that off with a dremel would I be voiding my...

Thanks. Never heard of that.

I hate to raise a dead thread, but I want to know if anyone has had any luck with the milling process on S&W 9mm EZ PC yet? I would like to put a Trijicon RMRcc.

I ended up with a Milt Sparks 200AW and a Galco Combat Master. The Galco conceals better, but the Milt Sparks is my favorite.

Is hoot a lot of 44 special, but I carry 44 magnums. It was the same when I first started in LE. It was shoot 38 and carry .357.

Thanks Pine. I will jump on it tomorrow.

I am in search for an original rear sight of anyone hears of one. From reading Brownells theirs only fit “modern” 629’s. I may be looking for something that will not be easy to find. Thanks

What is extra about the “Lee Horton?” I have The Standard Catalog S&W Second Edition book and I see nothing extra about the “Lew Horton.” Did they polish the trigger, change the hammers,etc...? Edit: those are the exact grips I bought for a lot of money. :)

I found the grips you mentioned. It took a while and was pretty expensive. I am okay with the sights.

Pizza Bob thanks for all the information.

I finally found me a 3” S&W 629-1. It is ported already and is in great shape. I sure would like it if someone could take the serial number and tell me something about the gun. It is a round butt and serial number is#AWF6673.

I hate to resurrect an old thread, but I just bought a S&W 629-1 with a 3” barrel on an auction. I am hoping it is round butt. I want know until next week. I asked the guy selling it and his replay was, well the end of the barrel is square/flat.” Ugh. I believe some of the 629-1’s were...

You guys are gigantic geniuses. When I begin taking it apart it was almost like they used axle grease and put it away never to be touched again. It took me a long time to clean it, but it is now as smooth as it can be. Just like butter. The cylinder turns freely and lock up is just as tight as...

Yes sir it all looks good and operates great. I think the guy so bought it from has used some kind of “gunk” for lubricant.

Would pulling out the cylinder and soaking in Balistol. Let it set and then wipe it down might do the trick?

Thank you.