32 Lemon Squeezer

[Suntzu04]

Good morning guys, I have a S&W safety hammer-less, 32S&W revolver, the issue I am seeing w it is that 4 of the 5 cylinders would shoot fine, but the other does not, however, when I cycle that chamber again, it would fire, any thoughts or suggestions? Thanks
Joe

 

[H Richard]

Is it the same chamber each time? It could be a matter of a good cleaning internally to clean out an accumulation of old oil and powder residue that's gumming up the works. That's the first place I'd look. If you have the correct type of screwdrivers, remove the side plate and spray out with brake & parts cleaner, gunscrubber, etc. and then wipe out and put a "few" drops of gun oil at the pivot points.

Welcome to the S&W Forum!