.38 Single Action Second Model Revolver with extended stocks

[mrcvs]

Are these stocks factory, or not? I haven’t seen these on this model before.

A poor fit would suggest they are not factory. However, many of the photographs make it difficult to determine if there is a gap of sorts between the frame and stocks or if it’s shadows or grit.

Antique Smith & Wesson Second Model 38 Single Action Revolver |




Guns & Military Artifacts

Handguns & Pistols

Revolvers

| Online Auctions | Proxibid

 

[glowe]

Absolutely not! Butt-frame dimensions from the beginnings of the 38 Single Action revolver remained the same until WWII. All stocks made in those 60+ years technically fit on any other gun. That includes the 38 SA 1st, 2nd, & 3rd, 38 DA, 38 Perfected, Single Shot pistol, and 32 Hand Ejector.

The stocks from the image appear to be from the Model 1891 Single Shot pistol, or from a model from that era.

 

[mrcvs]

Absolutely not! Butt-frame dimensions from the beginnings of the 38 Single Action revolver remained the same until WWII. All stocks made in those 60+ years technically fit on any other gun. That includes the 38 SA 1st, 2nd, & 3rd, 38 DA, 38 Perfected, Single Shot pistol, and 32 Hand Ejector.

The stocks from the image appear to be from the Model 1891 Single Shot pistol, or from a model from that era.

I suspected as much, but never say never when it comes to Smith & Wesson.

 

[mmaher94087]

That revolver is interesting. It appears that someone wanted a target .38. I find the whole concept intriguing, target stocks, target sight latch and bead front sight. Gunsmith special or S&W? Its nicely done either way.

 

[mrcvs]

That revolver is interesting. It appears that someone wanted a target .38. I find the whole concept intriguing, target stocks, target sight latch and bead front sight. Gunsmith special or S&W? Its nicely done either way.

It hammered at $325. Being antique, probably at your doorstep for around $400 after you figure in shipping and buyer’s premium. I didn’t bid, but I wish I did. The pre auction estimate of $600 to $900 scared me away.

 

[Boulder350]

They were an option for this model. It would have been late in production. I have never Seen one lettered.

 

[glowe]

The serial number on that 2nd Model was 279, built in 1877, long before those hard rubber target stocks were invented. It is possible that a 38 SA, 2nd Model, built in 1891 could could have been ordered with target stocks. They were available starting that year with the introduction of both the Model 1891 Single Shot and the 38 Single Action, 3rd Model of 1891.