forsyth793
Member
- Joined
- Mar 30, 2008
- Messages
- 71
- Reaction score
- 2
The Blade on My 686 is Loose and the Windage Screw doesn't Feel Positive. Is there an Upgrade and where can You Purchase Sight Parts?
686 Rear Sight Loose
- Thread starter forsyth793
- Start date
Register to hide this ad
That's normal. Rear blades typically pivot a few degrees front to back (unless they're crudded up), but the elevation variation caused by it is negligible.
OP
forsyth793
Member
- Joined
- Mar 30, 2008
- Messages
- 71
- Reaction score
- 2
Pivoting isn't the issue in this case, the blade moving right and left .080.
I haven't taken one of these sights apart yet to see Why. Are there any aftermarket upgrades available?
I haven't taken one of these sights apart yet to see Why. Are there any aftermarket upgrades available?
Protocall_Design
Vendor
Probably the nut on the left side has come loose. Maybe all you need to do is screw it back in and restake it. Screw it down till it touches, then back it off a tiny bit and stake it in place. There is a hole in the end of the screw for a punch.
OP
forsyth793
Member
- Joined
- Mar 30, 2008
- Messages
- 71
- Reaction score
- 2
Toolguy, Thanks for the Tip. I believe that is the problem, Now to find a Tool to fit in that Nut.........
Tupperware
Member
You can usually move it with a paper clip, just cut the small "u" shape out from the inside of it. Or you can make a slot up the middle of a flat blade screwdriver or buy the special tool from here:
BROWNELLS : SMITH & WESSON SIGHT NUT SPANNER - World's Largest Supplier of Firearm Accessories, Gun Parts and Gunsmithing Tools
