Alter or buy a new Trigger? (Model 36)

[time2swing]

Just took out my no-dash to the range for the first time today. She shot fine, but I hate the serrations on the trigger.

I've seen videos on how to use a Dremel to remove the serrations, but I'd like to keep the old one and replace them with something smooth. Suggestions?

 

[Old cop]

I like the serrations so I use a shooting glove when I'm going to fire more than 10 rounds.

 

[Rule3]

Step away from the Dremel! The tool of the Devil!

Shoot it more and build up a callous.

 

[F75gunslinger]

I'd say either get some shooting gloves or get a new trigger. Find the proper trigger and have it professionally fitted. Then you can shot it, and have the original trigger to keep the value. Either that..or look for another to trade for with the trigger you want.

 

[time2swing]

Guess I'll have to live with her. Can't make a Martin sound like a Stratocaster...I also don't want to ruin the value of the gun...

 

[armorer951]

The J-frame trigger discomfort/injury problem for me is not the serrations in the face of the trigger, but the sharp edge at the bottom.

You may be able to correct this by removing the trigger and knocking off this sharp edge. This can be done without "damaging" the trigger and is barely noticeable.....except to your finger.

Another alternative would be to purchase a new smooth trigger....fitting is usually required. Numrich has the slightly wider (.312), smooth triggers.......https://www.gunpartscorp.com/Products/309140.htm.

 

[chief38]

If the serrations bother you then get another trigger (the exact same one) and modify that one to your liking. Yes it might need some minor fitting but don't let that scare you away from getting what you want. Most of the time the fitting needed (if at all) is minor and can be easily done by a Qualified GS if you are not familiar with doing so yourslef. No reason to be uncomfortable when shooting a gun you like. Triggers are still available and try to get one in the same configuration and time period as yours but don't wait too long as they are getting harder to find in good condition and are getting more costly.

 

[Muss Muggins]

Just took out my no-dash to the range for the first time today. She shot fine, but I hate the serrations on the trigger.

I've seen videos on how to use a Dremel to remove the serrations, but I'd like to keep the old one and replace them with something smooth. Suggestions?

Dremel tool. Bench grinder also an option . . .

 

[Jaymo]

The only hammer and trigger I've ever been lucky enough to have had be a drop in replacement were for a Ruger GP100.

I need to get a replacement trigger for my 31-1 and 36, so I can remove the serrations.
I like the smooth trigger better. My 586 has one and it is sweet.

 

[H Richard]

I have done this with J Frame, K Frames, and L Frames that I shoot double action. Probably why S&W designed the mid size smooth "combat" trigger. Be sure to also contour the edges and to polish it to a fully smooth shiny finish.

 

[Biggfoot44]

Back during the Revolver Era , when they were practical guns to be actually used , this was very commonly done.

 

[Will2]

Had the same problem with my almost new M36. It's condition was almost new because I Just couldn't shoot it. Sanded just a little the sharpness off the serrations, maybe 10%. Works great.

Gun cost me $68 (new) when I was just a kid. I'll never sell it, so the loss in value wasn't important. Hated to deface it... but, it just hurt to shoot.

Will