Anyone Install A CMC Trigger Group?

[trebor127]

Yeehah, you'll be in hog heaven when that parcel finally arrives, have you thought about a barrel shroud? I really fancy one of the crown barrel shrouds from kineti-tech. stupid ITAR View attachment 159192
Cosmetic make up sure...but *wolf whistle*

i have this on the end of mine for now,but may cut 4inch off the

barrel and re-thread the end.





keith

 

[headcase650]

Can you not use the oem pins in the CMC trigger group?

 

[DSLKSL]

I believe the OEM pins are held in place by the trigger springs...The drop in trigger does not have those same springs.

 

[RedNeck Jim]

I believe the OEM pins are held in place by the trigger springs...The drop in trigger does not have those same springs.

Correct. CMC triggers come with their own pins, held in place by C clips. I am not a fan of such clips, so I use JP anti-walk pins on my AR & 15-22. Many like the KNS pins & they have a set specifically for the 15-22. I just note that CMC has their own anti-walk pins for the 15-22. I have never seen those before.
CMC Anti-Walk Pin Kit-For Smith & Wesson M&P 15-22 22LR

One concern with trigger pins is that the 15-22 lower receiver is wider than that of an AR. Thus, some pins will not work. I know from experience the JP pins work & know the other 2 pins mentioned are made specially for the 15-22.

 

[Just another 22 shooter]

I bought a CMC trigger from Brownells the first week of June for my Bush Master. It came with the anti walk pins with the hex head screws that screws into the end of the pins, not the c clips.

 

[RedNeck Jim]

I bought a CMC trigger from Brownells the first week of June for my Bush Master. It came with the anti walk pins with the hex head screws that screws into the end of the pins, not the c clips.

That is good to hear. I assume those pins would be too short for the 15-22, however DSLKSL states they do have an exchange program.

 

[Friggs]

I was on CMC's website a few days ago, and they say now all triggers are sent out with anti walk pins. And I did also see that on a venders site. But if you get old stock you might get the c clip pins. I don't know if their anti walk pins are long enough for the 15-22.

Bill