b/c gap

[gamedic]

A while back I replaced a badly rusted barrel on a model 10 I am going to give to my wife. I lost interest and am just getting around to permanatly installing the barrel. Refresh my memory what should my minimum barrel to cylinder gap be. Thanks

 

[S&W revolverman]

.004

Hope this helps
chris

 

[Maxw]

BC Gap

Factory is .004"-.010", I like .006" when I built match revolvers many years ago.

 

[Jebus35745]

Maxw, would you possibly have any ppc bbl's left over? I also need a rib for one, building a revolver if I can find parts. Can't find your e-mail in your profile. Larry

 

[Skip357]

Ihope you take all the endshake out of cyl.and yoke.And then install your bbl.B/C a round .004/.006ths.