Correct Extractor rod for model 19-3

Joined
Feb 11, 2012
Messages
1
Reaction score
0
I need helping finding the correct extractor rod for my Model 19-3 4" barrel. I had purchased an extractor rod from midwayuse for k frame S&W for 4" and up barrels yet it was just a little to long. Any Idea what the correct extractor rod is and where to purchase? Thanks
 
Register to hide this ad
Sir - The extractor rod you bought is probably the correct one. They have to be fitted to match up with the center pin (ie, they have to be shortened). If the center pin is good, no damage, then the rod can be fitted to assure the cylinder opens properly. Just requires a little careful filing on the end of the rod. Should be even and square after filing is completed. The end of the rod must be even with the center pin when the cylinder "thumbpiece" is fully fwd.
 
Back
Top