For Victory data base

chiefdave

US Veteran
Joined
Dec 4, 2017
Messages
1,119
Reaction score
2,952
City & State/Province
Warsaw, Missouri
V63138. Other than the normal barrel roll marks, logo, MADE IN USA and the S/N the revolver is void of any stampings. Most likely a DSC but could have gone anywhere. Will letter this one for sure. Finish is a bit faded but when I pulled the right stock off to check the number (matching) I found a lot of dried cosmoline that is only slightly softer than the steel.
 

Attachments

  • IMG_0094[1].jpg
    IMG_0094[1].jpg
    120 KB
  • IMG_E0094[1].jpg
    IMG_E0094[1].jpg
    119.8 KB
Chief Dave, Old armourer's trick to get rid of cosmoline: Get 55 gal. drum of diesel fuel. Build fire under the drum and heat until it's simmering. Drop in to the barrel, any ordnance that has been stored in cosmoline. Let simmer for a couple hours. Remove ordnance. Presto - No more cosmoline!
(No charge for the advice) Ed.
 
Chief Dave, Old armourer's trick to get rid of cosmoline: Get 55 gal. drum of diesel fuel. Build fire under the drum and heat until it's simmering. Drop in to the barrel, any ordnance that has been stored in cosmoline. Let simmer for a couple hours. Remove ordnance. Presto - No more cosmoline!
(No charge for the advice) Ed.

I may try that but have a couple of questions;

1. road or farm diesel?
2. Plastic or steel drum?
 
Chiefdave, Metal drum, of course, and diesel should be Millspec grade, after all your ordnance is clean, seal up the drum and return it to the Quartermaster's warehouse as it was a midnight requisition. (Been there, done that!) Ed.
 
Nice looking Victory, Chief. I will get it added to the Victory Database now.

Are you certain that there is no Ordnance bomb mark on the bottom of the butt?

Thanks.
 

Latest posts

Back
Top