Governor presents some cleaning issues

[GeorgiaShooter]

Yeah, love the Governor, went to range again today with it. Shooting the 45acp leaves residue rings in the cylinder that are very difficult to clean and also make the longer cartridges more prone to stick, using some products like the foam that sits in the bore for 15 minutes, and hoppes 9 but it's real work to remove these rings of residue. Any tips out there fire them my way.... thanks.

 

[dirtygrunt95]

Try M Pro 7 bore gel. I'm use it all the time to clean dirty guns at the shop I work at. Just run a dry brush through a couple of times, the put some on the brush run it through a couple of more times making sure you have a nice little coating on the insides. Wait 10-15 minutes and run some patches through until clean. I've used this method to clear AR bolt carries on suppresed gun.

 

[GeorgiaShooter]

Thanks I'll look for some of that. Might work better than this foam stuff I have been using.

 

[1 old 0311]

If it was mine? I would try to polish out the inside of the cylinder with some Flitz or Semi Chrome. Mothers is a little mild but Flitz should do the job.