BMCM

Question on which mag springs for a 3953. Midway has them for Product #: 137610 - assuming these are factory specific? But when I look...

Factory S&W part number 201650000 is correct for all variants of the M3953 including the TSW versions. In fact that red spring from...

Many thx Bill! 🙏🙏🙏

Good information, thank you. I am going try these M&P Shield retaining rings since I already have them, but I will definitely get some...

The original PC guys all walked out the door over time. Springfield shipped out the 3rd gen production (and then the repair) to the...

Deformation of the retaining ring like depicted above is a clear indication the ring is not properly sized to the shaft or groove...

Trigger no reset eh? Could be as simple as some goo gumming up the drawbar plunger spring. Or as not-simple as a cracked or broken...

Light hammer springs can certainly reduce a trigger pull weight, but thinking that a heavy recoil spring compensates for the increased...

Final update. Took her to the range this weekend and put 200 rounds down range. Gun ran flawlessly! Thanks for all the help. For your...

Bill was good enough to answer more concerns with a better description of what I was experiencing in DMs. He diagnosed a missing part I...

Bill's description of the DA trigger pull on the frame-mounted decocker pistols is spot on.

PVD is an applied coating whereas nitriding (under a pile of different trade names) is a form of case hardening. Surely you've see some...

Ok, I think I see what the issue is here. You're doing some dry-fire training and the first pull after decocking is from the half-cock...

I assume that spring you referred to is this one? That is the "decocking lever spring" Very easy to dislodge that when...

The 'timing' of the decocking is critical. Typically, when a new manual safety body is installed in a slide, the sear release lever in...