Hi
The S&W pistol I found out was a model 915 in 9mm with the de-cocking leverr.
The point of impact is to the lower right. I tried to move the rear sight in the dovetail but it wouldn't budge.
I looked for a pin but just couldn't see anything. I truthfully didn't look at the front sight at all. That may move easire.
How do you all adjust the fixed sights for windage on the S&W 915??
Does S&W use Loc-tite retainer there or what?
If so I could heat that with a jewlers torch, but I don't know how hot to get the sight to melt the Loc-tite.
Any info or advise would be helpful.
The pistol has fixed sights, so I guess to correct point of impact low I will need to buy a higher front sight.
Were can I get a S&W higher front sight? Dawson Precision???
Thanks for your help
The S&W pistol I found out was a model 915 in 9mm with the de-cocking leverr.
The point of impact is to the lower right. I tried to move the rear sight in the dovetail but it wouldn't budge.
I looked for a pin but just couldn't see anything. I truthfully didn't look at the front sight at all. That may move easire.
How do you all adjust the fixed sights for windage on the S&W 915??
Does S&W use Loc-tite retainer there or what?
If so I could heat that with a jewlers torch, but I don't know how hot to get the sight to melt the Loc-tite.
Any info or advise would be helpful.
The pistol has fixed sights, so I guess to correct point of impact low I will need to buy a higher front sight.
Were can I get a S&W higher front sight? Dawson Precision???
Thanks for your help
