I need to replace the BG2.0 Front Sight -

[ImDrRich]

Does anyone know the brand S&W uses OR is there a nearly identical brand I could buy?

My old eyes have trouble seeing the color red and the orange front sight is "derived" of red.

I'm looking for the same or similar sight in GREEN. No fiber optic sights.

Thanks guys.

 

[agksimon]

Does anyone know the brand S&W uses OR is there a nearly identical brand I could buy?
My old eyes have trouble seeing the color red and the orange front sight is "derived" of red.
I'm looking for the same or similar sight in GREEN. No fiber optic sights.
Thanks guys.

The closest sight I could find to fit was a Tru-Glo but it would just slide through by pushing by hand, but wasn't sloppy in there at all. It was made for the S&W Shield EZ9 and worked for me by using Permatex Orange thread locker, which is holding very tight. The rear sight is from the original Bodyguard first generation. Works very well for me and is much brighter than the original one from the factory.

 

[seldon14]

I'd just hit it with some green nail polish.

 

[Beju]

The closest sight I could find to fit was a Tru-Glo but it would just slide through by pushing by hand, but wasn't sloppy in there at all. It was made for the S&W Shield EZ9 and worked for me by using Permatex Orange thread locker, which is holding very tight. The rear sight is from the original Bodyguard first generation. Works very well for me and is much brighter than the original one from the factory.

If anyone else goes this route, you may be able to peen the front sight near the edge with a center punch to add mechanical tension/friction.