Installing Troy MRF 308 quad rail?

[daddy2twins]

I just received my Troy low profile gas block and I will receive my Troy MRF 308 quad rail/handguard 13.8" next week. Anyone have any threads on the installation of these two on the M&P 10?

Sent from my SCH-I605 using Tapatalk

 

[chrisreedrules]

Good luck getting the barrel nut off. It can be a real pita. I helped a buddy remove his and after that experience, I just went up to my local gun shop and bought it through them. It was cheaper than direct from Troy by about $15 and they installed it for me the day it came in.

 

[macliver]

Have your local gunsmith change the barrel nut. Start there. The rest is a walk in the park with the TRX.

 

[daddy2twins]

Yeah I may run into a little trouble finding someone local. I'll look.

Sent from my SCH-I605 using Tapatalk

 

[daddy2twins]

Have your local gunsmith change the barrel nut. Start there. The rest is a walk in the park with the TRX.

Any difference in installing the TRX vs the MRF 308?

Sent from my SCH-I605 using Tapatalk

 

[daddy2twins]

Would this wrench take care of everything as far as the removal and installation of the barrel nuts? Also, any need for a torque wrench? If so, got a link?

AR-15/M16/AR-STYLE .308 ARMORERS WRENCH | Brownells
http://www.brownells.com/gunsmith-t...6-ar-style-308-armorers-wrench-prod24190.aspx

Sent from my SCH-I605 using Tapatalk

 

[sgtsandman]

That tool should work. Yes, you will need a torque wrench. Hardware stores have them. Auto parts stores have them. Make sure it's 1/2" drive and can do 30-50 lbs-ft. They are fairly inexpensive to buy.