M&P 10 Gas Block size

[DakotaRaymond]

I recently bought a gas block from Troy Industries that I thought would fit but I guess not and there seems to be very little information on the web about the correct size. I bought the .750 1". Was I wrong?

 

[daddy2twins]

I recently bought a gas block from Troy Industries that I thought would fit but I guess not and there seems to be very little information on the web about the correct size. I bought the .750 1". Was I wrong?

Should be the right size. That's what I was told. I bought the same one I just haven't installed it yet.

Sent from my SCH-I605 using Tapatalk

 

[tcgrmt]

See the following from another post

The original gas block on my M&P 10 is a stepped hole. The 3/32" punch fits nicely in the hole but the pin is smaller than 3/32". After tying from both sides with the 3/32" punch with no luck and almost getting the punch stuck I tried the 1/16". The pin popped right out. With the pin and gas tube removed I cleaned the hole. The 3/32" punch will only go in about an 1/8" each side until it hits the step.

 

[DakotaRaymond]

See the following post
http://http://smith-wessonforum.com/newreply.php?do=newreply&p=137843253

The link didn't work for me.

 

[tcgrmt]

Sorry i thought it was the pin size you were looking for. I installed a 3/4" low profile on mine.
This is the the Troy version i installed

Amazon.com : Troy Low Profile Rifle Gas Block, Black, 0.75-Inch : Hunting And Shooting Equipment : Sports & Outdoors@@AMEPARAM@@http://ecx.images-amazon.com/images/I/41knEOCm7IL.@@AMEPARAM@@41knEOCm7IL

 

[bigchief]

i just put a troy .750 on mine, make sure you unscrew the hey bolts on the bottom mine were tightened a hair and wouldn't slide on at first