M&P 2.0 Compact Sear Deactivation lever is bent

[Richb60]

Hello - I recently tried to lower the sear lever to remove the slide and when I was ready to reassemble I forgot to lift the lever. I realized what happened and removed the slide, not I think the lever has a slight bend. I does lift up, doesn't look 100%, and it racks fine - took it to the range and went thru 8 mags with out an issue. Is there any thing I should be looking for or concerned about? FYI the gun is 1 month old.

TIA - Rich

 

[Doug M.]

That lever is not straight at all, so you may be perceiving something that is not a problem. Compare the lever to the drawings in your manual.

 

[shawn mccarver]

Or, post a picture. If you can insert a magazine all the way, then it is lifting up. Naturally, do not force the magazine or you could damage the magazine.

 

[Eric300]

If it looks like this, you're fine

 

[Richb60]

Sear possibly bent

Hope these came out ok. Maybe it is me, it looked not right, what does this group think?

 

[Eric300]

It's fine. Go shoot it.

 

[WR Moore]

Hello - I recently tried to lower the sear lever to remove the slide and when I was ready to reassemble I forgot to lift the lever.
TIA - Rich

You don't lift the lever until the slide is back on the gun. If you forget, the magazine will lift it, but you should check it.