Mod. 27-2 Bent Extractor Star

[3T'sX3]

Have a Model 27-2 with significant extractor rod run-out. I have replaced the extractor rod and center pin with new parts. Both of these parts are straight. I have determined that the shaft of the extractor star has a slight bow. This can be seen by rolling the shaft on a flat surface. Is their a method to straighten the shaft of the extractor star?

 

[Bullseye Smith]

It is hard to tell you how to do it, take it to a local smith and let him look at it or go to a gander mountain smith and he can replace it.

 

[500 Magnum Nut]

Assemble the entire assembly together less the cylinder. Make sure it's tightened up like it would be on the gun. Place it in a lathe or drill press arbor and then go about tapping it straight.

I had to do this on several as the threads on the extractor get bent real easily throwing off the entire ejector rod.

 

[judge]

If you decide you need a new M27 extractor (recessed heads only), we have them in stock. Blue steel, price $32.00 delivered. Thanks, Judge [email protected] (no PM please)