dnonac
Member
Below is a picture of the rebound slide, spring and internal rod from my newly acquired 6.5" 1977 Mod 29-2. I was inspecting the gun because of a really rough hitch in the trigger pull.
The rod inside the spring looks strange and I wanted to get some opinions from the experts.
As you can see, the forward end of the rod is smooth and looks fine, but I was concerned about the other end. It is blackened and rough on the edges. From the blackening, it appears that it might have been cut off and got hot? Anybody ever hear of this.
I haven't seen rebound internal rods from other guns and am wondering if the roughness on the rear could be causing the hitches; i.e., catching the rebound as it compresses. Or...I am wondering if someone has modified the part.
I am not certain what the function of this little rod would be unless it acts as a trigger stop.
Thanks in advance. All input appreciated....
The rod inside the spring looks strange and I wanted to get some opinions from the experts.
As you can see, the forward end of the rod is smooth and looks fine, but I was concerned about the other end. It is blackened and rough on the edges. From the blackening, it appears that it might have been cut off and got hot? Anybody ever hear of this.
I haven't seen rebound internal rods from other guns and am wondering if the roughness on the rear could be causing the hitches; i.e., catching the rebound as it compresses. Or...I am wondering if someone has modified the part.
I am not certain what the function of this little rod would be unless it acts as a trigger stop.
Thanks in advance. All input appreciated....
