Model 10-1 HB correct grips.

[thomp45acp]

I just located and put a model 10-1 HB in layaway. It has after market imitation pearl grips on it. What would
Be the correct factory grips for the weapon of 10-1?

 

[gmborkovic]

Hello thomp, tuff without a serial number. The 10-1 was into. Apr. 1959.
If early could be diamond magnas. If after 1968 probably non-diamonds.
Not hard to find after you ascertain date of mfg.

 

[Absalom]

Hello thomp, tuff without a serial number. The 10-1 was into. Apr. 1959.
If early could be diamond magnas. If after 1968 probably non-diamonds.
Not hard to find after you ascertain date of mfg.

I do believe that it's not that tough, as by 1968 and the disappearance of the diamond the 10-6 was the HB version in production and the 10-1 had not been produced for several years.

Rounded-shoulder diamond magnas it is.

 

[jimmyj]

wood magna grips with a diamond

 

[gmborkovic]

I know. That is where I was going. Thank you and best.

 

[DWalt]

Earlier postwar Magnas, until the early 1950s, had a different style, usually called the sharp shoulder. Afterwards, they had a sloped shoulder. Try eBay. Normally many are listed there. I think the earlier sharp shoulder Magnas look classier.

 

[murphydog]

One additional point, they would be the rounded bottom (modified or PC style) diamond Magnas, square butt. Good luck in your search.

 

[Absalom]

The attached picture shows the correct style. These are from 1959, so that would be the correct time frame.

 

[thomp45acp]

A lot of help. Thank you all!