Model 25-2 ACP swap cylinder for 45 LC?

Register to hide this ad
The .45 ACP cylinder on the 25-2 is shorter than the .45 Colt cylinders, so no, they won't fit.
 
A M25-2 cylinder can be fitted to a M25-3, as the M25-3 uses a shorter .45 Colt cylinder than the later (M25-5,-7) Colt revolvers. However, the headspace on an ACP cylinder is greater than that on a Colt cylinder and it will slide more to the rear before it hits the frame lug.
 
You could also fit a cylinder made from reaming an N frame 357 to 45 colt.

Any 45 colt cylinder fit to an 45 acp frame will also be about .035 longer to the rear. This means either the frame lug will need filed back that much or a nothch will need to be machined from the rear OD of the colt cylinder

The cut back frame luck is the usual method. This does allow the acvp cylinder to slop back that .035 while ejecting but the rounded tip of the center pin and the dimple in the recoil shield will smoothly slide it back forward upon closing
 
A -3 cylinder will work but they are unobtanium. The guy who said 45 Colt will work with moon clips (ericpolcrack) is wrong. That won't work.
 
Last edited by a moderator:
I was supposed to stop at two??...Somebody shoulda told me...:rolleyes:...Ben
Oh You are so Right !
I need to edit that post ...

... Lifes too short to have only ONE S&W revolver ...
Never pass up any excuse to buy another ... Never !

Is 6 enough ... is 12 too many ... Heck No !!!

Gary
 
Is 6 enough ... is 12 too many ... Heck No !!!

Gary
I did a safe census yesterday, and counted 118 Smiths for display, plus a few for carry and one project gun...Those figures may see some adjustment after my scheduled visits to three local gun shows this weekend...:o...Ben
 
A -3 cylinder will work but they are unobtanium. The guy who said 45 Colt will work with moon clips (ericpolcrack) is wrong. That won't work.

I have an M1917 that was converted by a previous owner to also chamber 45 Colt using moon clips from TK Custom. An M1917 cylinder is virtually identical to that of a 25-2. The chambers were just reamed to accept the Colts. The TK custom clips are the same ones they offer for Model 29s people have converted to use moon clips for competition. 45 ACP still works with moon/half moon clips. The clips are needed with the Colt rounds to insure proper headspace.
 
Last edited by a moderator:
Some one asked me how many revolvers I had. I told the truth. I don't know.

My story is ... " I don't Remember ! " ... and I'm sticking to it ...
You know the Memory is the first thing to go ... along with eyesight and hearing and joints and endurance ...
 
Back
Top