I have read alot on the forums and posted only twice ( this being one of those posts), I don't have alot to offer other than my wllingness to learn and a joy of shooting smith revolvers.
I just picked up a 32 hand ejector sn 413XXX. 3.25 inch barrel 4 screws in sideplate, 1 in front of trigger guard. all numbers match. From serial number it appears to be a third model, is that correct? But it is missing the following
1)extractor rod collar
2)extractor spring.
Any idea where I may pick these two parts up?
I looked at numrich,but nothing shown for HE and I was not sure if the newer jframe series parts would fit and if so which model to look up.
I sent an email to Bob's Gunshop as I have bought a few parts from them in the past. And I inquired at oldwestgunsmith.com.
I appreciate any help you can give me.
I just picked up a 32 hand ejector sn 413XXX. 3.25 inch barrel 4 screws in sideplate, 1 in front of trigger guard. all numbers match. From serial number it appears to be a third model, is that correct? But it is missing the following
1)extractor rod collar
2)extractor spring.
Any idea where I may pick these two parts up?
I looked at numrich,but nothing shown for HE and I was not sure if the newer jframe series parts would fit and if so which model to look up.
I sent an email to Bob's Gunshop as I have bought a few parts from them in the past. And I inquired at oldwestgunsmith.com.
I appreciate any help you can give me.
Last edited:
