After shooting about 150 rounds using both my 7 and 8 round magazines, I noticed that my magazine springs for both magazines were bent. I first found out when I could not get the last round into the 8 round magazine. I saw through the holes in the side that the top of the spring (the smaller part) was bent over 90 degrees. I contacted S&W and they are sending me a new spring. The next day I discovered that the same thing had happened to the 7 round magazine. I hadn't taken the mags apart until I found the problem.
I have attached a pic of the first spring.
Has anyone had this problem before? Is there a QC issue? Any recommendations for aftermarket springs that don't fail?
I have attached a pic of the first spring.
Has anyone had this problem before? Is there a QC issue? Any recommendations for aftermarket springs that don't fail?