Shield Trigger - Hard Wall?

[Fercho64]

For those shooting low just align the height of the rear and front sights and place the front sight dot over the target. DO NOT ALIGN THE DOTS. see if that works.

On my second SHIELD I just modified the striker block, cut the spring to .500, polished the sear on all sides and modified it to improved trigger reset.

 

[tcfiero]

Finally shot my 40 shield. I love this gun. I tried 180 grain and 165. The 180 groups were not as tight as the 165. The 165 in the shield felt the same as running 180 through my 40C.

Sent from my Kindle Fire using Tapatalk 2

 

[basswit]

My wife and I both own the 9mm. Her sights were off from factory. I clamped in a vise and used a steel block and hammer to move the front sights about 3/32 and now it is dead on. The trigger pull is much less and shorter than the LC9 I used to own. I have found the shield to shoot as good as my full size M&P9 or 45.