Show me some J frame Pics

[sprscientist]

632 UC. I haven't shot it yet but timing, barrel alignment, overall fit and finish seem very good.

 

[giguchan]

Here's my model 36 No Dash, carried in Uncle Mike's pocket holster and loaded with Underwood 150gr Wadcutters

That's Nickel right? looks a lot like SS in this photo.

 

[Exchipy]

632 UC. I haven't shot it yet but timing, barrel alignment, overall fit and finish seem very good.

That's how mine started out. But, I didn't much like the hard G-10 grips or the contrasting, black, small part accents. So, …



… thumb piece, ejector rod, and side plate screws were exchanged for stainless steel, and a Hogue Bantam grip was substituted. While I was about it, an 11 pound Wolff trigger rebound spring was also installed to improve double action. So now, it's just right for me, as I become more recoil sensitive in my advancing years.

 

[imashooter2]

A 360SC, I knew I was buying it the moment I picked it up. An 11.4 ounce .357 Magnum is a handful. I switched to +P .38s before I ingrained a permanent flinch.

And an M38 Airweight. I bought this for my Dad after he told me he couldn't rack the slide on his crappy (but completely reliable) Davis .380. It was his constant companion until his death. Now it is my daily carry. The few extra ounces are more than covered by the memories.

 

[MTC(SS)Ret]

Model 36 no dash 3", circa 1960, original numbered stocks in the safe, generic targets for shootin'.

 

[Simo]

Model 60-4. Bought in 1992.

 

[Drm50]

I'm down to 2 Jframes presently. A m37 and m34 4". Looking for a good deal on an old M38.

 

[Dino44]

My only engraved guns, happen to be J frames. The 640 is very near and dear to me. The engraver was a resident of my hometown. I went through grammar and high school with his grandchildren but at that young age, I knew nothing of his talents.

 

[sprscientist]

My only engraved guns, happen to be J frames. The 640 is very near and dear to me. The engraver was a resident of my hometown. I went through grammar and high school with his grandchildren but at that young age, I knew nothing of his talents.
View attachment 789342View attachment 789343View attachment 789344View attachment 789345

Damn, those are exceptional.

 

[imashooter2]

My only engraved guns, happen to be J frames. The 640 is very near and dear to me. The engraver was a resident of my hometown. I went through grammar and high school with his grandchildren but at that young age, I knew nothing of his talents.
View attachment 789342View attachment 789343View attachment 789344View attachment 789345

I really like that M38. As nice a job as I've ever seen.

 

[LEO918]

I'm down to one J frame - A Model 60, just like the first J frame I acquired in 1973. Was my first J and first stainless Smith & Wesson.