TARGET TRIGGER AND HAMMER INSTALL

[normanlclark]

Not a collector, nor even much of an accumulator; But I do have about a dozen N frames that I want to put target trigger and hammer on. Yes, I suppose it is very cost extensive, but so be it. The smooth target trigger is a must, and a target hammer is desirable. I already have some idea about the cost of the parts, and am looking for a ball park estimate for the installation. It is nothing I would attempt.

 

[chief38]

Not a very difficult job for a qualified G' Smith to fit and some actually do simply drop in. My experience is about 50%-50%. Since I do my own I can not tell you what G' Smiths are charging these days but if I had to guess I would imagine around $65 bucks for the ones that need minor fitting and about half for those that just drop in. I would bet that if you got the whole dozen done at the same time you might get a slight break.

Just be VERY CAREFUL that you buy the parts from a reputable dealer who is not selling parts that came out of problematic guns! New old stock parts would be your best bet if you can find them. Believe it or not they are still out there if you look hard enough........

 

[armorer951]

Cost of the parts will depend on the age of the firearms you want to convert, that is, whether or not you want to use "new" old stock forged or can use MIM parts, etc. I would guess that the parts will range from 75.00 - 100.00+ or more for each set, depending on new/used, MIM vs forged. You don't specify the types/vintage of the revolvers in question.

Labor will likely be at an hourly rate....anywhere from 40.00 - 60.00 per hour, or more, depending on where you live and who does the work.

Also, keep in mind that the adjoining OEM parts currently in your revolvers may not work with the replacement hammer/trigger combinations, and therefore will also have to be replaced and fit, which will add to the parts and labor costs involved.

 

[normanlclark]

Thank you for that excellent info. After I posted, I called a recommended gunsmith in Tucson. He suggested just bring one or two in at a time because parts could be an issue. I should have made the call before posting -duh-. His labor cost is very reasonable, and he seems very knowledgeable. I'm going to proceed with the project. Most all of my guns were purchased prior to 1976, many are from the 50s and 60s.

Thanks again for the reply's.

 

[iPac]

Frank Glenn in Scottsdale does great work, and has the best turn around time and price in my opinion and experience.