OK guys..Seriously need some help here..

It will clean up the residue as well[emoji1]
275f244a63f44bc85b25475d3f7746ad.gif
 
I make it a point to buy slow-setting anything when available ...

Gives you more time to get things right / unstuck .

My only experience has been with Super-Glue ... new stuff and I didn't know how to handle it ...

Acetone and a not too sharp , small pocket knife blade ... after softening with acetone ... pry the fingers apart without cutting the skin ...
A dull blade will help pry and not cut the skin apart ...

Good Luck ...
Slow setting beats Quick-Set , Seven Ways to Sunday !
Gary
 
This is why I come to the forum for expert advice! Heat does loosen Loctite . . . .

heh heh heh heh....

:D


To remove high strength Loctite thread locker you will need heat, up to 250° C. The heat will soften the thread locker, allowing the bolt to come loose.

After careful consideration I think not....but thanks for the information.
 
Back in 2007, I bought my last of 6 houses. 5 YO, plywood construction. Built by an architect for himself. I was in the cellar 1 day, and noticed they had not sealed around the pipe through the foundation to the septic tank.

Of to the depot to get a can of spray insulation. Got home, and sprayed the foam around the pipe to my satisfaction, but it was not smooth enough. Could not find a wide putty knife, So what to use? I have 2 hands, I will smooth it by hand.

Bad move. :eek: This is the most tenacious stuff known to man. it took days to get it all off, and a couple weeks for my hands to heal. Set up time is in pico seconds
 
Last edited:
Never had an issue with Gorilla Glue. In appropriate applications I have found it works well.

Returning to seriousness and Super Glue, I do put Super Glue into the cracks in my fingertips and carefully squeeze them shut. It keeps them from spreading and they heal quicker.
 
Back
Top