Search results

Gunbuyer had them this morning for $299.00. Got one today, have the older model with non threaded bbl but needed one threaded for a suppressor. Hard to pass this deal up, that's a very good price.

info sent to your PM. thanks

model ssar-sbs right hand....used very little perfect condition. will take $300.00 shipped, USPO money order for payment. first i'll take it followed by PM gets it. thanks for looking. SPF

cleaned mags, FP and spring made it about 50% better, will fire 10 rd mags flawless. pin was gummed up pretty bad as was the spring. ordered new firing pin, spring and roll pin...gonna change em out, seemed like things improved with cleaning and the old pin did look abused. if no improvement not...

thanks for mag tip. that ran thru my mind a few times but the springs in the mags seemed to be moving very freely, didn't noticed any rough spots while running the assist button a few times on each one. 22 ammo does throw a lot of junk out though. i'll give that a try and report back, never...

anyone have a remedy for light to no strikes on ammo? i have tried it all except a different firing pin spring. when it was first installed i ran close to a thousand rds with little to no problems at all. several mag dumps with no glitches, then slowly it kept slowing down to about 4-6 rds then...

i tried this on the timney #3 trigger but can't seem to calm it down. first of all the disconnector is with the red seal in it....correct?, it is the only set screw in the assembly. if so i removed the dab of plastic so access can be given for adjustment and turned counterclockwise very small...

just installed one of these in my 15-22 and am getting double and triple firing on a single pull. anyone ever have this happen?

little expensive but looks fun tho, Bump Fire with Slide Fire Stock on .22 Smith & Wesson 15-22 - YouTube

thanks to all for the replies. :cool:

thx for the link...got one on backorder.

mine is one of the earlier models...plain barrel. i put the 1/2-28 adapter (not sure what my plans are yet, thus the reason for the adapter) from tactical 22, was just looking for the factory suppressor. :cool:

two questions...is the threads on the 15-22 barrel mil-spec?, and....if any of you guys that have replaced the factory supp would you be interested in parting (cash) with it? i have the the mil-spec adapter on my barrel and would like the factory suppressor. or is this avail from the S&W...

i know this sounds crazy but...take the spring out of the mag and flip it around an reinstall. i had 2 mags w/all kinds of issues and did this....worked for me.

i went this way because not sure of my intentions (mods) yet. very nice adapter, the fit and finish match up real well. quick shipping also. :cool:

or......... push back pin out, open the rifle up, hold finger on the hammer and pull the trigger. let the hammer down real easy then close it back up. also while open you can inspect things after your outing.

thanks for the link on this deal, have plenty in storage but this was too good to pass by. very good deal considering it includes shipping. :cool:

"After that I load the mag with 25 rounds and the 1st round was fail to feed, the next 24 rounds were no problems." i had this same problem and it was the ones marked with ".22 lr 25 rds" i have 3 of them. try this...remove the bottom plate be careful an not to loose the follower plate, it...

not the best pic but has been a very good rifle. probably 5000 rds thru it and zero problems, prefix DTH. short mag makes good benchrest shooting.