I have a 1.0 9c
Bought a 2.0 compact barrel
The barrel fits in the slide fine, goes into battery, feeds snap caps, etc. But by hand, the slide will only travel 90% of the way back for locking, but as it almost gets there the barrel binds up.
I have used sharpie to show me the wear marks.
The front/top of the hood is getting binded to the underside of the slide. I have to tap the back of the slide to get it to release (without the slide catch being engaged).
Should/could I attempt to fit it to the slide or just accept the incompatibility (where to take material from? shave the angled hood? shave the underside of the slide?)
Bought a 2.0 compact barrel
The barrel fits in the slide fine, goes into battery, feeds snap caps, etc. But by hand, the slide will only travel 90% of the way back for locking, but as it almost gets there the barrel binds up.
I have used sharpie to show me the wear marks.
The front/top of the hood is getting binded to the underside of the slide. I have to tap the back of the slide to get it to release (without the slide catch being engaged).
Should/could I attempt to fit it to the slide or just accept the incompatibility (where to take material from? shave the angled hood? shave the underside of the slide?)