3rd gen help
- Thread starter WLB
- Start date
Register to hide this ad
boingboing
Member
Call the Performance Center. I just ordered bobbed hammers for my 5906TSW and 4006TSW
Try Numrichs.
They show the bobbed hammer in stock - Product # 351650 - $44.50
They show the .304 trigger, but its blue - Product # 361810 - $55.70
They have a toll free order line, may be worth a call - (866)686-7424
Hope this helps! Regards 18DAI
They show the bobbed hammer in stock - Product # 351650 - $44.50
They show the .304 trigger, but its blue - Product # 361810 - $55.70
They have a toll free order line, may be worth a call - (866)686-7424
Hope this helps! Regards 18DAI
boingboing
Member
3rd gen. parts
FYI- I just talked to S&W again and got a different gentleman who took the time to research it and advised that one for a 4516 would work by using my original longer hammer stirrup. It is on order but he said they should be in within two weeks. One down and one to go
FYI- I just talked to S&W again and got a different gentleman who took the time to research it and advised that one for a 4516 would work by using my original longer hammer stirrup. It is on order but he said they should be in within two weeks. One down and one to go
Last edited:
I changed my 4506 MIM hammer to a bobbed "stainless" from a 6906 I picked up cheap from Gunbroker. All I had to do was switch the longer 4506 strut to the 6906 hammer and it was a drop in fit.
Bobbed hammer is serrated on the top, so it's still possible to CAREFULLY cock for a single action shot, by slightly pulling the trigger, then thumbing the hammer back. ( I would STRONGLY suggest practicing this with an UNLOADED weapon, until comfortable, THEN limit LOADED useage to a range or other safe area.)
Last edited:
