586 trigger stop.

[rotty]

Hello guys.

The trigger stop in my 586 target champion seems to be threaded.

I noticed it was a bit loose and opened the side plate to tighten it a little and adjust it, but I can't do it as it seems that maybe the previous owner over tightened it and now it just stays loose.

As far as I can tell, the screw does not go all the way to the other side of the frame because I tried to put just the screw and it just freely goes in and out of the hole even after trying to tighten it. There is some thread in the trigger stop but it has a lot of play.

Can someone with one of these revolvers have a look and see if the stop is what attaches to the screw and if the screw in fact does not attach to the other side of the frame. I am convinced it does not because it does not look long enough anyway, but it will be good to get confirmation on this.

That way I can be sure what part I need to order from the importers here and see how much they want to charge for it.

As far as I can tell the stop is still available and the part number is 074430000.

Thank y'all.

 

[armorer951]

The screw only attaches to the stop body, not the frame itself. While you're at it, and if you can get one, order a new screw also.

 

[rotty]

Thank you very very much!

I will order the trigger stop and the screw and a set of side plate screws as there is one that has been forced before and looks a bit messy.

Now back to try to find those part numbers.

Cheers.

 

[rotty]

UPDATE: A smith in a local Aussie forum has a few trigger stops and screws in stock and has offered me a set for free!

How amazing is that?