67-1 Question
- Thread starter GreyEagle
- Start date
Can you confirm your 67 is a dash one? Your serial number may indicate it is a dash two or later. All the dash one guns I'm aware of were pinned and serial numbered in the "K" category. Just checkin'.
Last edited:
Engine49guy
Member
According to SCSW the DOB is around 1985,
My 67-1 is serial AHY 6291 and is also unpinned ,
The change to crush fitting barrels occurred during the Model 67 dash 1 production run and did not warrant a dash revision.
(Most blue K frames were in their dash 4 revision and the same changes are seen)
Early Mod 67 with Model 67-1 (top)
Note that the trademark also moved from the right side to the left side.
My 67-1 is serial AHY 6291 and is also unpinned ,
The change to crush fitting barrels occurred during the Model 67 dash 1 production run and did not warrant a dash revision.
(Most blue K frames were in their dash 4 revision and the same changes are seen)
Early Mod 67 with Model 67-1 (top)
Note that the trademark also moved from the right side to the left side.
Last edited:
Ashlander
Member
The Standard Catalog indicates that in 1982 S&W quit pinning the barrels of the 67-1 series but did not go to "-2" until 1988. So the early 67-1s were pinned while the later ones were not. The serial number looks like about 1985.
OP
GreyEagle
US Veteran
- Joined
- Feb 11, 2012
- Messages
- 55
- Reaction score
- 16
Serial number
I did a double check on the serial and the dash, both under the grips and inside at the back end of the barrel.... SN is AHV3XXX and under that it says 67-1. so yes I'm sure. Looks like a clean & tight 1985 model. Trademark is on the left side also.
Thanks for the info
GreyEagle
I did a double check on the serial and the dash, both under the grips and inside at the back end of the barrel.... SN is AHV3XXX and under that it says 67-1. so yes I'm sure. Looks like a clean & tight 1985 model. Trademark is on the left side also.
Thanks for the info
GreyEagle
Last edited:
Similar threads
