Some of you may have seen my post, if not, this is a recent find with a few problems, one of which was a bent cylinder shaft?
If I get the terminology wrong, I'm sure you will let me know!
Anyway, I was able to correct that issue, but the part the hammer rotates on has a broken screw and has had the end chewed up by someone less careful than me.
The question is, is this part available anywhere or does it need to be made?
Thanks, M
If I get the terminology wrong, I'm sure you will let me know!
Anyway, I was able to correct that issue, but the part the hammer rotates on has a broken screw and has had the end chewed up by someone less careful than me.
The question is, is this part available anywhere or does it need to be made?
Thanks, M
