help with info on a 32-20 please. Any and all Information is veru much appreciated !
- Thread starter newt43
- Start date
Register to hide this ad
Welcome to the Forum.
Demand for .32-20 revolvers dropped after World War One. S&W stopped production of .32-20 handguns in the late 1920s to 1930 era. Is there a "B" anywhere preceding the under-barrel serial number? If not, your revolver shipped with a nickel finish.
Please show pictures of the entire revolver. We can then determine if it has an original finish or has been refinished.
Also, please read this:
Demand for .32-20 revolvers dropped after World War One. S&W stopped production of .32-20 handguns in the late 1920s to 1930 era. Is there a "B" anywhere preceding the under-barrel serial number? If not, your revolver shipped with a nickel finish.
Please show pictures of the entire revolver. We can then determine if it has an original finish or has been refinished.
Also, please read this:
.
The members here are extremely helpful to people trying to identify guns.
However, many people do not post the data we need to help you, and we wind up playing 20 Questions for hours.
If you will take just a few minutes to read below and then post the data we need, you will sometimes see guns fully identified in 10 minutes or less! If you post at 4 am Eastern time, you might have to wait 2 or 3 hours for the morning crew to show up, but there's a good chance a west coast night owl will catch it for you.
Help us help YOU!
Start your own thread....
The members here are extremely helpful to people trying to identify guns.
However, many people do not post the data we need to help you, and we wind up playing 20 Questions for hours.
If you will take just a few minutes to read below and then post the data we need, you will sometimes see guns fully identified in 10 minutes or less! If you post at 4 am Eastern time, you might have to wait 2 or 3 hours for the morning crew to show up, but there's a good chance a west coast night owl will catch it for you.
Help us help YOU!
Start your own thread....
Last edited:
Thank you, great forum. Firearm was my father-is-laws. We believe it belonged to his dad or granddad. Would love any info or direction. Thank you
The Made in the USA stamp on the left-hand side indicates that it made after 1922 and before 1929 when they stop production. Your revolver has been refinished at some point in its life as the hammer and triggers were case hardened not nickel.
There is a good chance it left the factory in 1927. However, by that time the .32-20 was a very slow seller. Units serialized in that range shipped as late as 1930.
As noted above, it has been refinished, and the stocks are an aftermarket addition.
As noted above, it has been refinished, and the stocks are an aftermarket addition.
