gunhobbit
Member
After. Including the Kahr floorplate mod.
And yes, that's a 6906 hammer. I figured that since I was hating my pathetic life anyway I may as well do some S&W 3G gunsmithing and add that on, since I had it laying around.
As the videos BMCM so kindly linked for me ages ago said, "After you do it a few times, you'll remember."
What those videos DON'T say is, "You'll remember what a complete and total pain it can be!"
But that's not TercGen's fault.
Other fun issue - full size 3906 magazines don't insert smoothly. They stop at the point you can see there - wiggling gets them in, but still. Ones from a 3913 do just fine. Not sure what the issue there is, but not going to worry about it too much. And again, mags are not a TercGen issue.
SUPER highly recommend TG's grips - the grips went on smoothly. Look great. Feel great. And with any luck I'll get them out to the range tomorrow and acid test the varmints!
Thanks!!!!!
PS: Anybody want to buy a set of blubbery Hogue grips for a CS9?
And yes, that's a 6906 hammer. I figured that since I was hating my pathetic life anyway I may as well do some S&W 3G gunsmithing and add that on, since I had it laying around.
As the videos BMCM so kindly linked for me ages ago said, "After you do it a few times, you'll remember."
What those videos DON'T say is, "You'll remember what a complete and total pain it can be!"
But that's not TercGen's fault.
Other fun issue - full size 3906 magazines don't insert smoothly. They stop at the point you can see there - wiggling gets them in, but still. Ones from a 3913 do just fine. Not sure what the issue there is, but not going to worry about it too much. And again, mags are not a TercGen issue.
SUPER highly recommend TG's grips - the grips went on smoothly. Look great. Feel great. And with any luck I'll get them out to the range tomorrow and acid test the varmints!
Thanks!!!!!
PS: Anybody want to buy a set of blubbery Hogue grips for a CS9?
