wjh2657
Member
Has anybody out there had experience with holsters for a J-Frame with D&L sights installed? I am getting ready to send off my Model 60 for said installation, but I have determined that the completed weapon will not fit well into my 640/642 OWB holsters without hanging up on sights. As the gun is being set up for belt carry this poses a problem. I don't want a minimalist (slide) holster and nobody lists a good undercover holster for a 2" 60 with sights. All suggestions welcomed.
(This is not a discussion of whether D&L charges too much for their service. I know they are high, but there is a lot of smithing involved and I want good work done, so I'm willing to pay.)
Also, don't get into philosophical discussion about going to K-frame S&W. I have tried for 2 years to find a 19 or 65 for under $700 with no luck. My hands are small and J-Frames fit me perfectly. Gun is for EDC so the 5 shots vs 6 shots is not a major issue. I have the 60 and for $250 I can have the gun I want.
(This is not a discussion of whether D&L charges too much for their service. I know they are high, but there is a lot of smithing involved and I want good work done, so I'm willing to pay.)
Also, don't get into philosophical discussion about going to K-frame S&W. I have tried for 2 years to find a 19 or 65 for under $700 with no luck. My hands are small and J-Frames fit me perfectly. Gun is for EDC so the 5 shots vs 6 shots is not a major issue. I have the 60 and for $250 I can have the gun I want.