Model 64 question..

[SamuelGrath]

Hey guys have a question about a Model 64 I'm working on and I would like to put the older target hammer/trigger in case hardening on it. My question is will a model 10 parts work in this revolver? Thanks!

 

[ColbyBruce]

Probably, but the tapered barrel model 64 was only made for a few years and is not commonly seen for sale. Swapping parts will devalue it, in my opinion. If you want to dress it up, put a set of stag stocks on it.

 

[Martin67]

I would leave it alone, personally I can't get into stag grips. I couldn't come to an agreement on a model 67 because it had expensive stag grips. I asked how much without the grips. Just sell it bare.
I have a 64-5 and I'm leaving it as is especially since it's a DAO bobbed hammer LE trade in

 

[Ameshawki]

Yes with the proviso some fitting may be required and make sure you get the proper one for whatever dash model you have. Also note that hammers are fairly expensive. I wouldn't do it myself because I think it would look out of place.

 

[pharmer]

Another vote for leave it be. Joe

 

[SamuelGrath]

Stag grips..

Like this??

 

[SamuelGrath]

Had neck surgery performed after my spinal column collapsed on the nerve (thank you Obama care) so my hands and fingers are numb and the bigger purchase is appreciated!

 

[Engine49guy]

IMO Putting a wide target hammer / trigger on a tapered barrel 64 is like putting a set of 50's series drag slicks on a 71 VW Beetle...
but do what makes you happy.