More "I" frame .32

[olgeorge]

Members were very helpful in helping to identify and find a source for the missing rebound catch. Now I'm in need of a view of the inside(left side) of the hand. Numrich shows them "sold out", so If I have to make one I need to know the shape of the inside where the spring bears. Glowe's photos are excellent, but only show the outside and an angled view or the back of the hand. Thanks in advance, guys. L. O. G.

 

[H Richard]

Here is a 22/32 Heavy Frame Target "I" Frame internals I happened to have in my picture file if that helps.

 

[glowe]

Now I'm in need of a view of the inside(left side) of the hand. Numrich shows them "sold out", so If I have to make one I need to know the shape of the inside where the spring bears.

The hand is quite a complicated piece to fabricate and even with photos, it may well not work properly. What you need is an example to take detailed measurements from. I think that the only way to make a part that will work properly is to have one to model after. There are parts guns out there that may end up being the best way to go. You should be able to find a rusty beater, but it may take time.

 

[olgeorge]

Glowe: This one isn't rusty, but "beater" describes it pretty well. HRICHARD: This one is an early model with out the rebound slide and the hand is a different type.