MP9c frame rail chewed up?

[robb01]

So I finally got to shoot my new MP9c yesterday. I only had time to shoot 50 rounds through it. After I got home I field stripped and began to clean it, I noticed at the very front of the rail on the frame where the polymer seemed to be a little chewed up from the slide. It was a very small area that was like htis, but still concerning. Anyone else notice anything like this.

I don't have pictures at the moment because I'm at work, but can get some later this evening.

 

[Ranger98]

Would like to see the pictures

 

[iouri]

I think another member reported similar problem, he had edge of the frame kind of chipped. I'd suggest to call S&W customer support.

 

[robb01]

This is the best picture I could get. That area should be squared off, but its just a tad bit rounded off. Doesn't appear to be normal, but then again I'm probably just worrying

 

[insomniac]

i wouldn't worry about that. if it bothers you just take that sharp corner off with some toenail clippers.......then do the other side.

that area is not really the "frame rail", it's the dust cover.

 

[EvilBetty]

I think another member reported similar problem, he had edge of the frame kind of chipped. I'd suggest to call S&W customer support.

Another forum, but yes.
http://***************/boards/index.php?showtopic=32402

 

[S. Kelly]

You're worrying WAY too much.

 

[mcracco]

Another forum, but yes.
http://***************/boards/index.php?showtopic=32402

Shouldn't that be ************.COM?

 

[EvilBetty]

Shouldn't that be ************.COM?

Nice. *********** = mp-pistol . c o m