Need Revolver Reassembly Help

[Catbird33]

I have a S&W model 65-7. I currently have the trigger assembly and rebound slide assembly removed from the gun because I was trying to diagnose a problem with the hand spring tension.

I'm having a hard time figuring out exactly how the hand torsion spring (#29) is supposed to be installed. I've looked at Brownell's online schematic, but having problems visualizing the assembly procedure.

Can anyone help me, please?

 

[500 Magnum Nut]

look at the faq sticky above. I have a few pictures that will help you out.

 

[Catbird33]

Thanks for the info; I'll give it a try.

I don't have access to a rebound slide/spring tool. Do I absolutely need it or is there another acceptable solution when reassembling the rebound slide/spring? I can order it from Brownell's if I have to, but I'll probably never use it again after this one time.

I'm embarrassed to admit the the rebound spring went flying into the great unknown when I removed it. I thought I had it covered with my hand but obviously I didn't. If I can't find it today, I'll have to get one from Brownell's anyway.

 

[imashooter2]

A small Philips screw driver will work for the rebound slide spring.

 

[Catbird33]

That's good - I have plenty of those.

 

[mike4570]

Rebound spring

When you reassemble things, do it inside a gallon freezer bag. As someone who has chased flying springs and parts around the shop this will really help.
Mike

 

[imashooter2]

...And safety glasses.

Ideally the Philips should be just a bit larger than the ID of the spring.