Non adjustable 4506 sight alignment

[lowwill]

Quick question on my 4506 the mag disconnect somehow got damage from the slide. Cant figure how that happened. So I removed it from the slide. Upon doing so I cant figure out how to align the rear sight back to spec. Is there a certain measurement or just hit the range and tap tap tap. Figured I will do anyways. How do you guys align the front with the rear sight. Thanks

 

[armorer951]

I use a magnifier, and carefully move the sight base to a position in the slide that leaves the same amount of vacant space exposed in the base of the sight cut at each side/end of the sight body. The front sight should be in the center from the factory, unless you've removed or changed it.

If you believe that there's a possibility the windage may need to be adjusted, take the tools to the range.

 

[Fazer386]

I'll 2nd, center the rear sight then range time. Tap the rear sight until you're zero'd. Once you're zero'd, scribe a line to mark the sights position. This way you'll know the sights correct position if you need to remove or replace the sight.