Sight pusher on ebay

[randyr5]

Hi, Does anyone have experience with this sight pusher on M&P's, especially the Shield?

Handgun Front Rear Sight Pusher Universal Sight Tool Glock Sig 1911 Others | eBay

 

[S&W45Colt]

I have one and have successfully used it on Glocks and M&P's with no issues. I have not specifically used it on a Shield, so I can't say for sure it will work, though I imagine it will.

 

[Murphy's Law]

There's a guy who makes a great sight pusher on the 1911 forum called the MK III & MK IV that will work on just about any gun for both front/back sights. Cost around $70. You should have no problem finding the posts doing a search. This guy has sold hundreds of his design.

 

[epj]

There's a guy who makes a great sight pusher on the 1911 forum called the MK III & MK IV that will work on just about any gun for both front/back sights. Cost around $70. You should have no problem finding the posts doing a search. This guy has sold hundreds of his design.

I'll save you the trouble of searching: http://smith-wessonforum.com/access...ew-mk-lll-xtreme-duty-model-m-p-xd-rated.html

 

[johnnymg]

I have a very similar version sold by "The Glock Store". It worked excellent (on a Glock) AFTER I replaced the outside locking nut that was tearing up the threads on the large bolt.

cheers
JohnG

 

[Dafish]

Try sightpusher.com

 

[Mushki]

I also have a sight pusher like the guy above me from sightpusher.com and am very pleased with its versatility. It has worked on every gun I have thrown at it.

 

[MarTay6]

I, too have one of these sightpushers. The M&P Shield's can be particularly difficult to move the original sights on- actually broke a sightpusher (early version) on it... the tip broke off. He sent me a hardened version, and it's been fine. The guy gives great service. The Shields can be a BEAST to remove the sights from- I ended up having to cut the rear sight in half with a small cut-off disc in a Dremel... it just simply would NOT budge, even after blaster soakings, etc. Heard they install them with hydraulic presses at S&W- I'd believe it.
Wes

 

[epj]

If you had a JMT pusher with the correct pusher pins, the Dremel would not have been necessary.

 

[epj]

There's a guy who makes a great sight pusher on the 1911 forum called the MK III & MK IV that will work on just about any gun for both front/back sights. Cost around $70. You should have no problem finding the posts doing a search. This guy has sold hundreds of his design.

This pusher originated on this forum. It is for sale in the classifieds here. Works with M&P' of all descriptions, inclulding Shields.

 

[VM]

This isn't the feedback section, but I've met epj in person and had a postive/great transaction.

 

[Mike McLellan]

This isn't the lounge section, but why are all the recliner chairs taken by old farts?