You could fix it yourself and you don't need a cabinet...
Eastwood is known for their auto restoration tools and supplies.
You need a compressor, a small one is fine as long as you can create 50 psi at the gun.
You need safety goggles.
You need a water filter or trap that will reduce moisture in the air line as you bead blast. If water is mixed with the air, the nozzle will clog.
Eastwood website:
Abrasive Blasting - Media, Pressure Blasters, Soda Blasters, Blast Cabinets
Select the Speed Blast Gravity Feed Blaster for 60 bucks.
Thru Brownells they sell the glass beads. DO NOT use sand blast media, it's different.
BROWNELLS : BROWNELLS : GLASS BEADS - World's Largest Supplier of Firearm Accessories, Gun Parts and Gunsmithing Tools
The 270 is very fine, (this is what I use)
I also redo rifles and this has to be outside because they won't fit inside a cabinet.
When bead blasting you hold the nozzle 6" or so away from the work. You spray it back and forth to create the look you want, then flip the work and continue on the other sides. it's best to remove all the gun sights or tape them up well, because the beads will remove the bluing on the sights.
It's very easy to bead blast, just make sure the part to be blasted is clean, well prepared so no tool marks are seen. Bead blasting won't hide dents or heavy scratches so it's best to polish, sand or file these areas before you blast. After I'm done I wash all the parts with water in the sink and use compressed air to completely dry the parts before assembly.
It's a trial and error approach, but I assure you, you can't screw up bead blasting!
